Welcome to the Water Rocket Forum, sponsored by The Water Rocket Achievement World Record Association.

Since our founding in 2003, we've become the largest, most sophisticated and ground breaking group supporting you, the serious water rocket flyer! Whether you are a beginner or an expert, the WRA2 has something for everyone.

A water rocket is a type of model rocket using water as its reaction mass. The pressure vessel (the engine of the rocket) is constructed from thin plastic or other non metallic materials (usually a used plastic soft drink bottle) weighing 1,500 grams or less. The water is forced out by compressed air. It is an example of Newton's third law of motion.

:WRA2: Newest WRA2 members: :WRA2:

Shalini from New Delhi, India,
Kevin Colvill from Hailey, Idaho, USA,
and Rich Overbeck from Dallas Tx, USA

How do keep cable ties from slipping?

Discussion about Compressors, hose, pipes, fittings, launchers, release mechanisms, and launch tubes.
User avatar
anachronist
WRA2 Member
WRA2 Member
Posts: 76
Joined: Sun May 07, 2017 2:18 pm
Location: Mountain View, California
Contact:

How do keep cable ties from slipping?

Postby anachronist » Sun Aug 13, 2017 3:00 am

During pressure testing of my launcher (first I've ever built) I noticed the cable ties slipping with each launch, to the point where the launch tube o-ring ended up right at the lip of the bottle.

Well, I was using only one hose clamp to hold the ties. So I took it apart, repositioned the ties, even managed to fit in 3 more ties to distribute the load some more, and used THREE hose clamps to secure them. I noticed a small space under the screw side of the hose clamp, so I made sure to fasten each hose clamp with the screws 120° apart so that every cable tie gets squeezed by at least 2 hose clamps.

It's still slipping. Not as much, but definitely slipping. I notice the cable tie heads about 3-4 mm above the collar of the bottle now, after just one pressure test.

Any suggestions? I'm thinking of sanding the smooth sides (which are against the launch tube), and gluing them with PL adhesive before clamping them. But I'd rather have a solution that doesn't involve glue if possible.
User avatar
addstogether2
WRA2 Member
WRA2 Member
Posts: 43
Joined: Sun Mar 15, 2015 1:25 am
Location: Melbourne Australia

Re: How do keep cable ties from slipping?

Postby addstogether2 » Sun Aug 13, 2017 4:05 am

Just a suggestion, Some cloth binding tape/ gaffa tape under the cable ties gives it something to press into and gripp.

I found that worked for me.

Al
Life is like riding a bicycle. To keep your balance you must keep moving.
"Albert Einstein"