Welcome to the Water Rocket Forum, sponsored by The Water Rocket Achievement World Record Association.

Since our founding in 2003, we've become the largest, most sophisticated and ground breaking group supporting you, the serious water rocket flyer! Whether you are a beginner or an expert, the WRA2 has something for everyone.

A water rocket is a type of model rocket using water as its reaction mass. The pressure vessel (the engine of the rocket) is constructed from thin plastic or other non metallic materials (usually a used plastic soft drink bottle) weighing 1,500 grams or less. The water is forced out by compressed air. It is an example of Newton's third law of motion.

Water in Gardena Launcher

Discussion about Compressors, hose, pipes, fittings, launchers, release mechanisms, and launch tubes.
Post Reply
Thort
New Member
Posts: 3
Joined: Sun Nov 05, 2017 1:13 pm

Water in Gardena Launcher

Post by Thort » Sun Nov 05, 2017 1:27 pm

Hello everyone,

I'm building a gardena launcher and I've realised that when I'll fill the rocket with water it will fall in the PVC pipes. Is this going to be a problem? Is it possible that the water enters in the compressor? Which is the best way to solve that?

Thanks for your answers



User avatar
anachronist
WRA2 Member
WRA2 Member
Posts: 106
Joined: Sun May 07, 2017 2:18 pm

Re: Water in Gardena Launcher

Post by anachronist » Mon Nov 06, 2017 2:22 am

That's one reason I don't use gardena nozzles.
However, you can make a one-way valve in the launcher part, from a ball bearing and a cone (like the end of a ball point pen). This is done with 2-stage mechanisms that use a gardena connector between the stages. See this tutorial: http://www.instructables.com/id/Water-R ... Mechanism/ and you'll see the one-way valve starting at step 12.



Thort
New Member
Posts: 3
Joined: Sun Nov 05, 2017 1:13 pm

Re: Water in Gardena Launcher

Post by Thort » Tue Nov 07, 2017 2:19 pm

I'm not sure it will adapt to my launcher.
The launcher I built it's similar to this one http://www.uswaterrockets.com/construct ... torial.htm
What do you think about this system?. It isn't perfect but it looks like it works: https://www.youtube.com/watch?v=UEzRSgfUumI



User avatar
anachronist
WRA2 Member
WRA2 Member
Posts: 106
Joined: Sun May 07, 2017 2:18 pm

Re: Water in Gardena Launcher

Post by anachronist » Tue Nov 07, 2017 3:56 pm

Step 3 in that web page is ridiculous. Don't bond a schrader valve to a PVC pipe. Use a tank valve with an NPC adapter. Or better still, use compressor fittings as shown in this post. Compressor fittings are cheap and reliable.

In the picture in step 6 or 7, you'd want that gardena release part to be attached to a PVC check valve, like this one at Home Depot. You'll still get a bit of water in the vertical part but at least it won't fill up the launcher pipe.



Post Reply