My launcher so far

Discussion about Compressors, hose, pipes, fittings, launchers, release mechanisms, and launch tubes.
User avatar
Chonchielopez
Advanced Member
Advanced Member
Posts: 16
Joined: Sat Jul 25, 2009 1:49 am

My launcher so far

Post by Chonchielopez »

This is just showing what i have on my launcher so far, so anyone can make suggestions.
Attachments
This is how my flexble hose connectes to the booster filler.( the booster filleres are not held down because I had romved the locking tabs and springs. None of this would have been possible without george.)
This is how my flexble hose connectes to the booster filler.( the booster filleres are not held down because I had romved the locking tabs and springs. None of this would have been possible without george.)
Drakes boosters 002.JPG (1.66 MiB) Viewed 143 times
This is the cross for my 3 boosters. the problem with this is I need to connect a bike pump to one end and the threading is compression thread, any help???
This is the cross for my 3 boosters. the problem with this is I need to connect a bike pump to one end and the threading is compression thread, any help???
Drakes boosters 001.JPG (1.65 MiB) Viewed 143 times
This will hold my main stage and will hold my boosters down
This will hold my main stage and will hold my boosters down
Drakes Scenery 050.JPG (1.7 MiB) Viewed 143 times
How my bike pump connects to my main stage.
How my bike pump connects to my main stage.
Drakes Scenery 049.JPG (1.64 MiB) Viewed 143 times
Launchers are hard to make