My Hozelock / Gardena Launcher - 15mm Copper fittings

Discussion about Compressors, hose, pipes, fittings, launchers, release mechanisms, and launch tubes.
Post Reply
mac_xpert
WRA2 Member
WRA2 Member
Posts: 8
Joined: Wed Nov 07, 2018 12:09 pm

My Hozelock / Gardena Launcher - 15mm Copper fittings

Post by mac_xpert » Tue Nov 13, 2018 6:02 am

For info and to help others with ideas, here is my launcher:
Launcher.jpg
Its made from some ply that i had laying around. I used 15mm copper pipe and compression fittings to 'plumb' it all together. It has a check valve (non return) to prevent water entering the air pump. It has a valve for filling / releasing pressure if needed.

Here is a picture of it pre launch:
Launcher_ready.jpg
You do not have the required permissions to view the files attached to this post.



Post Reply