Fibreglass Bottle reinforcement - Initial Failures

Discussions about water rocket powered cars, sleds or boats.
atvan
WRA2 Member
WRA2 Member
Posts: 17
Joined: Sat Mar 17, 2012 7:00 pm

Re: Fibreglass Bottle reinforcement - Initial Failures

Post by atvan » Wed Mar 21, 2012 6:55 pm

Do you use the 45° wings for downforce as well as for yaw stabilization?


Beware the Purple.

User avatar
RaZias
WRA2 Member
WRA2 Member
Posts: 751
Joined: Mon Jul 14, 2008 3:16 pm

Re: Fibreglass Bottle reinforcement - Initial Failures

Post by RaZias » Wed May 09, 2012 12:45 pm

You are going to use 3 nozzles of 15mm each.

I presume you will be using 15mm gardena nozzles at 260 psi.
(if the pump is the Topeak JoeBlow Ace Floor)

The 15mm female part are only connectable with a plastic quick-release.
(there isn´t a metalic quick-release for 15mm).

Therefor I wonder if the quick-release won´t blast at 260 psi... :roll:


Research and Development is the soul of WR

User avatar
Prodigy Rocketry
WRA2 Member
WRA2 Member
Posts: 23
Joined: Sun Nov 24, 2013 12:18 pm

Re: Fibreglass Bottle reinforcement - Initial Failures

Post by Prodigy Rocketry » Sun Nov 24, 2013 3:35 pm

I was in Harbor Frieght and saw some fully brass disconnect style (gardinia type) fittings very cheap. Was thinking about getting them to try but have too many irons in the fire now for a new releas project.


Any opinion can be raised, but few grow up to become facts.

Post Reply