Being an avid SCUBA diver, I happen to have some spare equipment. With the purchase of a trigger activated valve (with its own pressure gauge) and a new fitting for my "Launch Cube" (with another pressure gauge, and a shut off valve--so I can fall back on the foot pump, if needed) I can now reach 120psi without exhausting myself and all my time. How high can I get?
I can't wait to try it out.
No more Bicycle pumps!
-
- WRA2 Member
- Posts: 61
- Joined: Sat Feb 16, 2013 3:39 am
No more Bicycle pumps!
- Attachments
-
- Modifications to the Launch Cube
- 2013-03-20 16.37.51.jpg (644.61 KiB) Viewed 103 times
-
- High and Low Pressure Gauges
- 2013-03-20 16.36.06.jpg (1.21 MiB) Viewed 103 times
-
- Filling Station
- 2013-03-20 16.35.44.jpg (1.05 MiB) Viewed 103 times
"Houston, we've had a problem..."
-
- WRA2 Member
- Posts: 61
- Joined: Sat Feb 16, 2013 3:39 am
Re: No more Bicycle pumps!
Several successful launches today. Only had one bottle splice fail (at 100psi)... that woke up a few neighbors... and one flight went much higher than any of my previous flights. Too bad I didn't get any film of it, or an altimeter reading (no place for it in that specific rocket, yet).
Very glad I did this.
Very glad I did this.
"Houston, we've had a problem..."
-
- WRA2 Member
- Posts: 124
- Joined: Sat Dec 15, 2012 12:12 am
Re: No more Bicycle pumps!
Looks like a nice setup. I use a 12 volt compressor in addition to a 6 gallon tank and fill with a similar trigger. I'm assuming you fill slowly because otherwise heat builds up quickly with pet.
-
- WRA2 Member
- Posts: 442
- Joined: Mon Apr 09, 2012 3:49 pm
Re: No more Bicycle pumps!
Wow! That is great setup you got. Must be nice. I have wanted to upgrade to a scuba tank for a long while. Too expensive for now.
-DogLover
-DogLover
-Blenderite
Check out my YouTube channel: https://www.youtube.com/c/Blenderite
"Get it right, then go for GREATNESS!"
Check out my YouTube channel: https://www.youtube.com/c/Blenderite
"Get it right, then go for GREATNESS!"
-
- WRA2 Member
- Posts: 74
- Joined: Wed Feb 27, 2013 6:00 pm