compressed inner rubber tubing seal instead of the o ring design?
Just like the o ring design with cable ties or fingers, but with a section of rubber that gets compressed into the nozzle ID while engaging the ties/fingers to the nozzle flange?
Anybody here use the launcher design with the compressed..
-
Nick B
- Internet Troll
- Posts: 347
- Joined: Tue Apr 03, 2012 8:47 pm
Anybody here use the launcher design with the compressed..
Nick and Dad B.
-
T86157
- Advanced Member
- Posts: 27
- Joined: Wed May 02, 2012 11:25 pm
Re: Anybody here use the launcher design with the compressed
http://www.proprofs.com/flashcards/upload/a1993796.jpg
No. I alternatively used a rubber stopper like the one shown above. That seems to work with a lot of nozzle sizes. It compresses if you force the nozzle down far enough. What I found helps using a rubber stopper is to lubricate it with oil so the nozzle can come off easier while still retaining a strong seal. I am going to try o-rings next...
No. I alternatively used a rubber stopper like the one shown above. That seems to work with a lot of nozzle sizes. It compresses if you force the nozzle down far enough. What I found helps using a rubber stopper is to lubricate it with oil so the nozzle can come off easier while still retaining a strong seal. I am going to try o-rings next...